Pole Top Hole Drilling Machine

POLE TOP HOLE DRILLING MACHINE

(Automatic type, 6 or 8 holes once finished drilling)

Model : FD10 (for max hole diameter 10mm,  thermal friction drilling type)

1.Application:

It is suitable for light pole top fixing holes quick drilling process.

1. Purpose and Process

It is suitable for the fast drilling process of fixing holes on the top of light poles.

Using the principle of thermal friction drilling, 6 or 8 holes can be completed in one go. While completing the holes, the length of the tapping is increased based on the original plate thickness (for example, the thickness of the street light pole is 4mm, and after the drilling process, the length of the threaded section can be 8-10mm). After hot-dip galvanizing,

Complete the tapping process manually again.

This can eliminate the traditional process of welding nuts. Good looking and saving process time.

Put the light pole on the machine, the machine top stop will control the first 3 or 4 holes to top of the pole distance. Push the start button, the pneumatic clamp will clamp the pole first, then the 3 or 4 drilling heads will finish 3 or 4 holes first , then the clamping system will move pole to next position to do drilling automatic, until finish, the 3 or 4 drilling heads will stop and return back the original position.

All these processes are automatic. Press only one start button and all steps will be completed.

3 or 4 power units, in a vertical plane, perpendicular to the street lamp pole.

The machine is equipped with two installation locations and can be equipped with three or four uniformly distributed power heads. Used for processing 6 or 8 holes, customers choose to adjust according to their requirements.

The thermal friction drilling process is a tool made of tungsten carbide hard alloy with special wear resistanc

2.The main technical indicators：